Tutorial Connecting the grandMA 2Port Node with MXWendler via Art-Net: Difference between revisions
Jump to navigation
Jump to search
(Created page with "In this tutorial we will connect a grandMA onPC software with a grandMA 2Port node. The onPC software will send Art-Net, which which will be used to control a MXWendler medias...") |
No edit summary |
||
Line 5: | Line 5: | ||
[[File:04 IPConsole.PNG]] | [[File:04 IPConsole.PNG|300px]] | ||
:'''01.''' Open the network adapter settings | :'''01.''' Open the network adapter settings | ||
Revision as of 18:37, 23 November 2015
In this tutorial we will connect a grandMA onPC software with a grandMA 2Port node. The onPC software will send Art-Net, which which will be used to control a MXWendler mediaserver.
Configure the grandMA onPC PC system
- 01. Open the network adapter settings
- 02. Open 'Erweitert...' / 'Extended...'
- 03. Add a second IP adress in the Art-Net range. The netmask of 255.0.0.0 is important.
Configure the grandMA onPC software
- 04. Open MA Setup, create a new session
- 05. Open DMX nodes, add the node, set Ma-Net2 mode, set session id that matches the previously created session.
- 06. Open Network Protocols, enable Art-Net, enable DMX output, set universe and subnet as shown.
Configure the MXWendler Mediaserver PC system
- 07. Open network adapter settings, enter a valid Art-Net IP adress. The subnet mask of 255.0.0.0 is important.
Configure the MXWendler Mediaserver software
- 08. Open Settings → IO → Art-Net/DMX → Select adapter, universe and subnet as shown.