Capture Cards (e.g. BM Decklink Studio2): Difference between revisions
No edit summary |
No edit summary |
||
| Line 5: | Line 5: | ||
''Solution:'' | ''Solution:'' | ||
1. Open "Live Devices" from "Settings/Media-Pictures, video and live media" | |||
2. Mark the Checkbox "Open Live Device Settings on Start" | |||
[[File:LiveDevices.png|640px]] | [[File:LiveDevices.png|640px]] | ||
3. Change state of your Live device by double-clicking | |||
4. Set state to known and enter your Capture values | |||
[[File:LiveDevice_state.png|340px]][[File:LiveDevices_state_known.png|340px]] | [[File:LiveDevice_state.png|340px]][[File:LiveDevices_state_known.png|340px]] | ||
Now a Video dialog should appear with a preview of your live device | |||
[[File:Video_LiveDevice_dialog.png|728px]] | [[File:Video_LiveDevice_dialog.png|728px]] | ||
5. Start FXServer/StageDesigner | |||
6. Open New Clip in Live Editor | |||
7. Select LiveMedia in DropDown Menu | |||
[[File:LiveMedia_LiveEditor.png|480px]] | [[File:LiveMedia_LiveEditor.png|480px]] | ||
| Line 30: | Line 34: | ||
'''Using BlackmagicDesign Capture Cards with Windows 7''' | '''Using BlackmagicDesign Capture Cards with Windows 7''' | ||
1. Setup your Capture Card in Control Panel "BlackmagicDesign Control Panel" | |||
2. Check in Blackmagic Media Express if there is a signal | |||
3. If there is a signal in Black Magic Media Express, write down the exact figures eg. 1920 x 1080 x 50p | |||
4. In the Stage Designer live media window, DO NOT use the Blackmagic WDM device, use the Decklink device: '''WDM->unknown''', '''Decklink->known''' with the exact figures you noted before | |||
5. Reduce latency: set Stage Designer / FXServer framerate ''higher'' than capture card latency | |||
[[File:BM_System_Settings.PNG|480px]] | [[File:BM_System_Settings.PNG|480px]] | ||
Revision as of 16:19, 27 March 2019
This applies to Mac OS 10.7 and MXWendler version 4.2 and above (Windows see below)
Problem:
- You can find your Capture Cards in Live Devices, but there is no video signal.
Solution: 1. Open "Live Devices" from "Settings/Media-Pictures, video and live media"
2. Mark the Checkbox "Open Live Device Settings on Start"
3. Change state of your Live device by double-clicking
4. Set state to known and enter your Capture values
Now a Video dialog should appear with a preview of your live device
File:Video LiveDevice dialog.png
5. Start FXServer/StageDesigner
6. Open New Clip in Live Editor
7. Select LiveMedia in DropDown Menu
File:LiveMedia LiveEditor captur.png
Using BlackmagicDesign Capture Cards with Windows 7
1. Setup your Capture Card in Control Panel "BlackmagicDesign Control Panel"
2. Check in Blackmagic Media Express if there is a signal
3. If there is a signal in Black Magic Media Express, write down the exact figures eg. 1920 x 1080 x 50p
4. In the Stage Designer live media window, DO NOT use the Blackmagic WDM device, use the Decklink device: WDM->unknown, Decklink->known with the exact figures you noted before
5. Reduce latency: set Stage Designer / FXServer framerate higher than capture card latency
