Capture Cards (e.g. BM Decklink Studio2): Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 8: | Line 8: | ||
*2. Mark the Checkbox "Open Live Device Settings on Start" | *2. Mark the Checkbox "Open Live Device Settings on Start" | ||
[[File:LiveDevices.png| | [[File:LiveDevices.png|640px]] | ||
*3. Change state of your Live device by double-clicking | *3. Change state of your Live device by double-clicking | ||
*4. Set state to known and enter your Capture values | *4. Set state to known and enter your Capture values | ||
[[File:LiveDevice_state.png| | [[File:LiveDevice_state.png|640px]] | ||
[[File:LiveDevices_state_known.png|400px]] | [[File:LiveDevices_state_known.png|400px]] | ||
| Line 24: | Line 24: | ||
*8. Select LiveMedia in DropDown Menu | *8. Select LiveMedia in DropDown Menu | ||
[[File:LiveMedia_LiveEditor.png| | [[File:LiveMedia_LiveEditor.png|640px]] | ||
[[File:LiveMedia_LiveEditor_captur.png| | [[File:LiveMedia_LiveEditor_captur.png|640px]] | ||
| Line 34: | Line 34: | ||
:[[File:BM_System_Settings.PNG| | :[[File:BM_System_Settings.PNG|640px]] | ||
Revision as of 17:10, 20 February 2019
This applies to Mac OS 10.7 and MXWendler version 4.2 and above (Windows see below)
Problem:
- You can find your Capture Cards in Live Devices, but there is no video signal.
Solution:
- 1. Open "Live Devices" from "Settings/Media-Pictures, video and live media"
- 2. Mark the Checkbox "Open Live Device Settings on Start"
- 3. Change state of your Live device by double-clicking
- 4. Set state to known and enter your Capture values
- 5. Now a Video dialog should appear with a preview of your live device
File:Video LiveDevice dialog.png
- 6. Start FXServer/StageDesigner
- 7. Open New Clip in Live Editor
- 8. Select LiveMedia in DropDown Menu
File:LiveMedia LiveEditor captur.png
Using BlackmagicDesign Capture Cards with Windows 7
- 9. Setup your Capture Card in Control Panel "BlackmagicDesign Control Panel"
- 10. Check in Blackmagic Media Express if there is a signal
- 11. If there is a signal in Black Magic Media Express, write down the exact figures eg. 1920 x 1080 x 50p
- 12. In the Stage Designer live media window, DO NOT use the Blackmagic WDM device, use the Decklink device: WDM->unknown, Decklink->known with the exact figures you noted before
- 13. Reduce latency: set Stage Designer / FXServer framerate higher than capture card latency