Difference between revisions of "Capture Cards (e.g. BM Decklink Studio2)"

From MXWendler Wiki
Jump to navigation Jump to search
Line 40: Line 40:
 
*11. If there is a signal in Black Magic Media Express, write down the exact figures eg. 1920 x 1080 x 50p
 
*11. If there is a signal in Black Magic Media Express, write down the exact figures eg. 1920 x 1080 x 50p
 
*12. In the Stage Designer live media window, DO NOT use the Blackmagic WDM device, use the Decklink device: '''WDM->unknown''', '''Decklink->known''' with the exact figures you noted before
 
*12. In the Stage Designer live media window, DO NOT use the Blackmagic WDM device, use the Decklink device: '''WDM->unknown''', '''Decklink->known''' with the exact figures you noted before
 +
*13. Reduce latency: set Stage Designer / FXServer framerate ''higher'' than capture card latency

Revision as of 11:28, 14 September 2018

This applies to Mac OS 10.7 and MXWendler version 4.2 and above (Windows see below)

Problem:

  • You can find your Capture Cards in Live Devices, but there is no video signal.

Solution:

  • 1. Open "Live Devices" from "Settings/Media-Pictures, video and live media"
  • 2. Mark the Checkbox "Open Live Device Settings on Start"

LiveDevices.png

  • 3. Change state of your Live device by double-clicking
  • 4. Set state to known and enter your Capture values

LiveDevice state.png LiveDevices state known.png

  • 5. Now a Video dialog should appear with a preview of your live device

Video LiveDevice dialog.png

  • 6. Start FXServer/StageDesigner
  • 7. Open New Clip in Live Editor
  • 8. Select LiveMedia in DropDown Menu

400px

LiveMedia LiveEditor captur.png


Using BlackmagicDesign Capture Cards with Windows 7

  • 9. Setup your Capture Card in Control Panel "BlackmagicDesign Control Panel"


BM System Settings.PNG


  • 10. Check in Blackmagic Media Express if there is a signal
  • 11. If there is a signal in Black Magic Media Express, write down the exact figures eg. 1920 x 1080 x 50p
  • 12. In the Stage Designer live media window, DO NOT use the Blackmagic WDM device, use the Decklink device: WDM->unknown, Decklink->known with the exact figures you noted before
  • 13. Reduce latency: set Stage Designer / FXServer framerate higher than capture card latency