Tutorial Connecting the grandMA 2Port Node with MXWendler via Art-Net

From MXWendler Wiki
Revision as of 16:03, 30 September 2019 by Behrooz (talk | contribs)
Jump to navigation Jump to search

To use this feature a Windows operative system is required.


In this tutorial, we will connect a grandMA onPC software with a grandMA 2Port node. The onPC software will send Art-Net, which will be used to control an MXWendler mediaserver.


Configure the grandMA on PC System

1. Open the network adapter settings, assign interface a primary MA-Net2 IP address. ( here 192.168.4.254 )

2. Open 'Erweitert...' / 'Extended...'

3. Add a secondary interface IP address in the Art-Net range ( recommended 2.x.x.x ). The netmask of 255.0.0.0 is important.

Configure the grandMA on PC Software

4. Open MA Setup, create a new session on the MA-Net2 IP ( here 192.168.4.254 )


5. Open DMX nodes, add the node, assign it an MA-Net2 IP address ( here 192.168.4.250 ), set Ma-Net2 mode, set session-id that matches the previously created session.

{{#mpdftags: pagebreak}}

6. Open Network Protocols, enable Art-Net, enable DMX output, set universe and subnet as shown.


{{#mpdftags: pagebreak}}

Configure the MXWendler Mediaserver PC System

7. Open network adapter settings, enter a valid Art-Net IP address. The subnet mask of 255.0.0.0 is important. (A)

Configure the MXWendler Mediaserver Software

8. Open Settings → IO → Art-Net/DMX → Select adapter, universe and subnet as shown. (B)