View source for Tutorial Eventmaster Toolset Controlling MXWendler by e.g. e2 S3 Image Processor

This tutorial applies to all different OS and MXWendler versions > 6.0.04

== Introduction==
This tutorial explains how to set up a Barco Eventmaster to trigger and control media playback on StageDesigner or FXServer.

==Control Setup==

1. Open SD (StageDesigner) and load a clip into preload 1:

[[File:e2_01.png|600px]]

2. Open Settings->IO->Barco e2 and activate TCP listening. Also note down the port number.

[[File:e2_02.png|600px]]

3. In the Barco Eventmaster Toolset, create an 'External Device', name it e.g. 'StageDesigner'.

[[File:e2_03.png|600px]]

4. In the 'Adjust: StageDesigner' tab, set IP address and port number.

[[File:e2_04.png|600px]]

5. In the 'Adjust: StageDesigner' tab, add a new command. Store the command content, e.g.
* /mxw/preload/1 play to start a clip
* /mxw/preload/1 play to stop a clip

More possible commands are in the OSC control section: [[3._MXW_OSC_command_reference]]

[[File:e2_05.png|600px]]

6. In the 'Cue' section, add a cue.

[[File:e2_06.png|600px]]

7. In this 'Cue', add actions.

[[File:e2_07.png|600px]]

8. From 'External Devices' drop an available command onto the 'Commands' field of the action.

[[File:e2_08c.png|600px]]

9. Play this cue, a clip should be started in the StageDesigner