Capture Cards (e.g. BM Decklink Studio2): Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 14: | Line 14: | ||
[[File:LiveDevice_state.png|640px]] | [[File:LiveDevice_state.png|640px]] | ||
[[File:LiveDevices_state_known.png| | [[File:LiveDevices_state_known.png|640px]] | ||
*5. Now a Video dialog should appear with a preview of your live device | *5. Now a Video dialog should appear with a preview of your live device | ||
[[File:Video_LiveDevice_dialog.png| | [[File:Video_LiveDevice_dialog.png|640px]] | ||
*6. Start FXServer/StageDesigner | *6. Start FXServer/StageDesigner | ||
Revision as of 15:10, 20 February 2019
This applies to Mac OS 10.7 and MXWendler version 4.2 and above (Windows see below)
Problem:
- You can find your Capture Cards in Live Devices, but there is no video signal.
Solution:
- 1. Open "Live Devices" from "Settings/Media-Pictures, video and live media"
- 2. Mark the Checkbox "Open Live Device Settings on Start"
- 3. Change state of your Live device by double-clicking
- 4. Set state to known and enter your Capture values
- 5. Now a Video dialog should appear with a preview of your live device
File:Video LiveDevice dialog.png
- 6. Start FXServer/StageDesigner
- 7. Open New Clip in Live Editor
- 8. Select LiveMedia in DropDown Menu
File:LiveMedia LiveEditor captur.png
Using BlackmagicDesign Capture Cards with Windows 7
- 9. Setup your Capture Card in Control Panel "BlackmagicDesign Control Panel"
- 10. Check in Blackmagic Media Express if there is a signal
- 11. If there is a signal in Black Magic Media Express, write down the exact figures eg. 1920 x 1080 x 50p
- 12. In the Stage Designer live media window, DO NOT use the Blackmagic WDM device, use the Decklink device: WDM->unknown, Decklink->known with the exact figures you noted before
- 13. Reduce latency: set Stage Designer / FXServer framerate higher than capture card latency